Dynatrol Products - Level Detection, Viscosity & Density Measurement

Main » Solids Level Switch » Product Details

Dynatrol® GJ Level Switch for Light Bulk Solids

The Dynatrol® CL-10GJ Level Detector operates with consistent results on problem applications that have a tendency to bridge or pack. It handles difficult products such as flour, cocoa, sugar, pharmaceutical powders, powdered lime and additional bulk solid materials for high-, intermediate- or low-point level detection. The CL-10GJ is typically used with bulk solids in the density range of 10-15 lbs/ft3.

Dynatrol® GJ Level Switch for Light Bulk Solids


Dynatrol® Level Detectors are constructed for a long operating life, require no field adjustments and can be modified for special level detection applications such as:  

 •  Temperatures up to 750°F
 •  Cryogenic temperatures
 •  Chemical corrosion
 •  Media requiring special coatings
 •  Detection of the interface between liquids and bulk solids materials
 •  Simple installation. Installation is made in the tank wall through a 3/4-inch, half-coupling at the point of desired level detection.

With the CL-10GJ, reliable operation can be achieved in problem applications where other types of controls may fail to operate at all.  Let Automation Products, Inc. provide a worry‐free solution for you today!

CL-10GJ Specifications

 •  Explosion Proof: CSA NRTL/C approved for Class I, Groups C & D; Class II, Groups E, F & G; Class III
 •  Temperature Rating: 300°F (High Temperature Construction Available)
 •  Pressure Rating: 1000 PSIG @ 100°F (Consult Factory for higher ratings)
 •  Pressure Connection: 3/4-inch NPT

 •  Conduit Connection: 1/2-inch NPT

 •  Used with the Dynatrol® G Series Level Detectors for exceptional sensitivity in measurement.

 •  Explosion Proof: CSA NRTL/C approved for Class I, Groups C & D; Class II, Groups E, F & G; Class III
 •  Voltage Supply (Nominal): 120 volts -50-60 Hz (also available in 240 VAC and 24 VDC)
 •  Power Consumption: 5 VA
 •  Temperature Rating: 125°F Maximum
 •  Contacts: SPDT 2A @ 120 VAC (Non-Inductive)

Principle of Operation

The Dynatrol® GJ Level Detector consists of a paddle-style probe which is installed through the wall of the bin or duct at the point of desired level detection. When the probe is uncovered the paddle is free to vibrate and produce an output signal. This signal operates a relay indicating the paddle is uncovered and a low level exists. When the paddle is covered a dampening of the oscillation occurs. The resultant loss of signal de-energizes the relay indicating that a high level exists.


Request a quote or information

Please fill out the fields that apply to your interest. After completing the form, click "Send" located under the Comments field. You will be returned to the General Information tab. To ensure your inquiry was sent, return to the Request a Quote tab and check for errors.

* denotes mandatory field