Dynatrol Products - Level Detection, Viscosity & Density Measurement

Main » Solids Level Switch » Product Details
  

Dynatrol® GS Level Sensor Switch for Low Density Bulk Solids


The Dynatrol® GS Level Sensor Detector is designed for application to high, intermediate, or low point level detection of bulk solids. The GS Level Detector successfully handles lightweight media applications that are difficult to measure or detect like fine low density powders, flock, fluff or fumed silica, etc.The CL-10GS is typically used with bulk solids in the density range of 5-10 lbs/ft3.





Dynatrol® GS Level Sensor Switch for Low Density Bulk Solids


Advantages

 •  Versatile:  This level detector operates successfully with consistent results on product applications such as light-weight, free       
     flowing media typically in the range of 5-10 pounds/cubic foot.
 •  No Adjustment Needed:  All level switch components have been constructed for long operating life and require no field adjustments.
 •  Simple Installation:  Installation is made in the tank side through a 3/4-inch, half-coupling at the point of desired level detection.

CL-10GS Specifications


 •  Explosion Proof: CSA NRTL/C approved for Class 1, Group D, Division 1
 •  Temperature Rating: 300°F (Consult Factory for higher ratings.)
 •  Pressure Rating: 1000 PSIG @ 100°F (Consult Factory for higher ratings.)
 •  Pressure Connection: 3/4-inch NPT
 •  Conduit Connection: 1/2-inch NPT


EC-501A(G) Control Unit Specifications

 •  Explosion Proof: CSA NRTL/C approved for Class 1, Group D; Class II, Group E, F & G; Class III
 •  Voltage Supply (Nominal): 120 volts - 50/60 Hz
 •  Available in 24 VDC and 240 VAC
 •  Power Consumption: 5 VA
 •  Temperature Rating: 125°F Maximum
 •  Contacts: SPDT 2A @ 120 VAC (Non-Inductive)


Principle of Operation

The Dynatrol® GS Level Sensor consists of a paddle-style probe which is installed thorough the wall of the bin or duct at the point of desired level detection. When the probe is uncovered the paddle is free to vibrate and produce an output signal. This signal operates a relay indicating the paddle is uncovered and a low level exists. When the paddle is covered a dampening of the oscillation occurs. The loss of signal de-energizes the relay indicating that a high level exists.

The level switch is mounted through a ¾-inch NPT half-coupling at the point of desired level detection. The On/Off signal from the Dynatrol® CL-10GS Detector operates a SPDT relay in the EC-501A(G) Control Unit. The contacts of this relay can be used to actuate level alarms, indicator lights or process control equipment.


Click links for more information


Low Density Powders

Photos



Request a quote or information


Please fill out the fields that apply to your interest. After completing the form, click "Send" located under the Comments field. You will be returned to the General Information tab. To ensure your inquiry was sent, return to the Request a Quote tab and check for errors.

Send
* denotes mandatory field